Graco TrioGrow SnugLoc Manuals | ManualsLib
Looking for:
User manual Graco SnugRide SnugLock 35 LX (English - 80 pages) - Need help? |
GRACO TRIOGROW SNUGLOC INSTRUCTION MANUAL Pdf Download | ManualsLib - Need Help?
The TrioGrow SnugLock 3-in-1 is a similar carseat but as its name suggests, it only offers 3 modes of use: rear-facing, forward-facing, and highback booster. I chose a spot in about the middle of the padded area from which to measure.
I was also able to place it behind the passenger seat in the most upright position and the passenger seat was pretty far back. My preference with tensioning devices like the SnugLock is to use the seat belt for installation.
The seat belt can be easily adjusted more tightly or loosely if needed to close the lockoff versus the LATCH belt where you must sometimes deal with a stiff adjuster. Probably the most challenging part of the installation will be moving the LATCH strap from the rear-facing belt path to the forward-facing belt path. Pull all the LATCH connectors close together, then slide it up the metal bar; slide it behind the harness and through the forward-facing belt path. Fortunately, we have a video to show you how:.
Other types of inflatable seat belts are still incompatible for use with the TrioGrow. When installing the TrioGrow with an inflatable seat belt, make sure the SnugLock lockoff is closed and thread the seat belt over the top of it.
Lock the retractor to make sure the seat belt stays tight. Body support pad: Use rear-facing only; must be used if shoulders are below the lowest harness setting; once shoulders are above the lowest harness setting, use is optional. Here he is again in booster mode. You can see the combination of the angle at which the shoulder belt comes out of my vehicle seat and how it hits the shoulder belt guide causes it to curl a bit, but it still sits flat on his chest. The cover can be thrown in the washing machine on gentle cycle.
Hang to dry. Removing and replacing the covers can be considered easy. I really like the Rapid Remove cover because you can select the section that needs to be cleaned instead of washing the whole thing. The cup holders are required to be attached. The harness design is a 1-harness-slot design with the slot set high up on the carseat. As your child gets older and taller, there will be less friction and it will be easier to use.
I know that every ounce counts when your plane is at that last gate in the airport they always are! This carseat has a lifespan of 10 years from the date of manufacture. It must be replaced after any crash, including a minor one. The TrioGrow SnugLock has the look of the 4Ever and installs with the ease and familiarity of the SnugLock rear-facing only infant seat. No other compensation was provided. All opinions expressed are those of the author. Casn you tell me how this seat dimensions compare to the Graco slimfit 3in 1 car seat?
I need to be able to fit a car seat for our 9 month and 2 boasters as well across the same seat. Hi Michelle, the original SlimFit model is going to be similar to the TrioGrow in width, but one or the other may puzzle better next to a particular booster. Hi Justin. No, the SnugRide bases are only used with the SnugRide rear-facing only infant seats with the handles. The next step seats—convertibles and all-in-ones—are leave in the vehicle seats.
Any suggestions? Hi Kelli. The headrest is touching her shoulders? Graco seats with adjustable headrests can be kind of tough to figure out because they push down on the harness for fit instead of using traditional harness slots.
Hi Ariane. Do you mean the insert pillow? You can remove it at any time since its use is not required. Thank you so much for this review!
Graco read my mind! My daughter is very small for her age 3. Providing the cute models was super helpful too! My guy is very small.. Hi Ali. My baby is 5 months 18lbs and 20 inches. Hi Nonnie. This site uses Akismet to reduce spam. Learn how your comment data is processed. Rear-Facing Installation When rear-facing, any of reclines can be used to achieve an appropriate recline. You will also have to remove the front corner of the side cover in order to have room to get to the small-ish belt path.
Forward-Facing Installation Kiddos under 40 lbs. Booster Installation The harness is stored on-board in the storage compartment. You get a smaller compartment in order to have a fabulous lockoff; tradeoffs, I suppose. If the LATCH strap or connectors interfere with the vehicle buckle or seat belt in any way, store it through the forward-facing belt path on the carseat instead. The recline position must be set to position 6, which is most upright. Fit to Child: The TrioGrow has a head support, body support pad, and harness covers.
She fit nicely in the TrioGrow. G is 6 years old and weighs 43 lbs. The TrioGrow was roomy for him and he was pretty comfy. Related Posts. SafeDad September 30, Justin O April 28, We have the snugride Snuglock 35 already with 2 bases.
Will this use the same base? Heather April 30, Kelli Gregory April 14, Heather April 14, Ariane Donais April 10, I would like to know when you can remove the head wings? At what age or weight?
Thank you!! Heather April 10, Maria March 21, Kecia March 21, Ali October 3, Heather October 5, Nonnie July 28, Heather August 3, Leave a Reply Cancel reply.
Graco triogrow snuglock manual. Graco TrioGrow SnugLoc Instruction Manual
Graco triogrow snuglock manual
Table Of Contents. Quick Links. Table of Contents. Previous Page. Next Page. Page 6 According to the AAP , these infants may suffer breathing issues if improperly reclined in a car seat. When rear-facing, use the corrected age for preemies. Graco advises that you have your physician or hospital staff evaluate your infant and recommend the proper car seat or car bed before To attach the cup holders, match the right cup holder to the right side of the seat and the left to the left.
Page 9 According to accident statistics, the safest place for your child in any vehicle is the back seat. The center of the back seat can be the safest during a possible side impact. LATCH consists of lower anchors and top tether anchors, which are built- in to your vehicle, and connecting hooks that are built-in to your car seat. Review section 6. Buckle Position C The correct slot is the one that is closest to your child without being underneath them.
Position Shoulder Belt Shoulder belt lies across shoulder between neck and edge of shoulder. Page 18 1-B Welcome to the Graco Family! No car seat can guarantee protection from injury in every situation, but proper use helps reduce the risk of serious injury or death. Even if this car seat seems easy to figure out on your own, you must follow the detailed instructions in this instruction manual to ensure all steps are preformed correctly. Page 19 1-C Right Mode of Use 5 lb 22 lb 40 lb 65 lb lb 2.
Page 20 Child restraints could be recalled for safety reasons. You must register this restraint to be reached in a recall. Attn: Customer Service P. Box , Elverson, PA Page 21 For future reference or if you change addresses, record the model name, model number, date of manufacture and purchase date of this car seat on the below.
You can find this information either on the registration card if you still have it or on the date label located on the back of the car seat. Page 22 STOP using this car seat and throw it away 10 years after the date of manufacture. Look for this sticker on back of the car seat. We also advise against purchasing a car seat second hand.
Page 23 Warm Weather Use Car seat parts can get very hot in the sun or warm weather. To avoid burns, always check before putting child in car seat. Children are safer riding rear-facing and should ride rear- facing as long as possible, until they reach the maximum rear-facing height or weight rating for their car seat. Visit www. Their use could alter the performance of the car seat.
If using vehicle Never leave child unattended, even when sleeping. Child may become tangled in harness straps and suffocate or strangle. Page 28 2-A Car Seat Features Page 37 AAP , these infants may suffer breathing issues if improperly reclined in a car seat. Graco restraint rear-facing in a advises that you have your vehicle seating location physician or hospital staff Use corrected age for preemies. Store Top Tether Strap Attach tether hook to the plastic bar on right side of the car seat.
Page 40 3. Recline the Car Seat Pull out on handle on front of child restraint and adjust to one of the three rear-facing positions. Page 41 5. The base should sit as flat as possible on the vehicle seat. Page 42 7. For easier installation, extend the LATCH strap to its maximum length by pressing the grey button and pulling on the strap. Loosen the harness straps. Push down on the harness release lever while pulling out on the harness straps at the chest clip. Page Raise the headrest to the highest position.
Unbuckle the buckle. Unbuckle the chest clip. Page 44 E. Unsnap Seat Pad Undo the 2 snaps. Lift the headrest pad flap up out of the way. Page 45 9. Proceed to the next step if the SnugLock Lock-off is already in the Page 46 Make sure the LATCH strap is in front of the buckle strap when the buckle is in the inner-most position, and behind when in the outer-most position. Page 47 Do not pull on the strap with excessive force.
You may need to tighten through the rear-facing belt path as shown. Page 48 Replace the Seat Pad Move the headrest back to its proper position for your child. Page 49 Ball must completely be in the blue area. Readjust if needed. For infants 3 months and under, the ball must completely be in the light blue area. If needed, rolled towels may be placed under the car seat at the vehicle seat crease, until the ball is completely in the blue area. Page 50 Is Everything Correct?
Page 52 3. Graco TrioGrow SnugLock — rear facing 8 month old. This model is 8 months old, she weighs 22 pounds and is 29 inches tall. She was quite comfortable with it installed upright, and enjoyed the more L shape of the seat. She has plenty of room to grow and use this seat rear facing for many more years. Graco TrioGrow SnugLock — rear facing 2 years old.
This model is nearing her 3rd birthday. She weighs 25 pounds and is She has plenty of leg room though we know that is not a safety concern , and thought the seat was very comfortable.
Her mom was happy with the seats low stance, it made loading and unloading a bigger rear facing child easy. The low sides also appealed to this model as she could reach her nearby toys easily. Graco TrioGrow SnugLock- rear facing 4 year old. This model is just shy of her fifth birthday and is 42 inches tall and weighs 38 pounds. The first step with a forward facing installation is to ensure that the anti-rebound bar has been removed again, push the buttons on the side of the TrioGrow SnugLock , and that the top tether has been removed from the storage location.
The TrioGrow SnugLock may be installed forward facing on reclines 4, 5, or 6. Graco TrioGrow SnugLock — moving the lower anchors along the metal bar.
The lower anchors are attached to the TrioGrow SnugLock by a metal bar down the inner right side of the seat. To move the lower anchors between the forward facing and rear facing belt paths:. Extend the headrest all the way to the top, and undo the snaps attaching the seat pad to the seat.
Pull the bottom seat pad back to expose the plastic shell and lift the headrest pad out of the way. Pull the LUAS connectors out of the belt path and slide the webbing along the bar to the correct belt path front of the seat for rear facing and back of the seat for forward facing. Route the lower anchor connectors through the correct belt path, ensuring no twists, and replace the seat pad. Note: When rear facing, the LUAS webbing must pass between the two crotch buckle slots in front of the inner slot and behind the outer slot.
Position the seat on recline 4, 5, or 6, and ensure the LUAS strap is routed through the forward facing orange belt path. Loosen the harness and raise the headrest to the highest position and undo the snaps to unsnap the seat pad.
Graco TrioGrow SnugLock installed forward facing with seatbelt. Position the seat on recline 4, 5, or 6, and ensure the LUAS is routed through the rear facing blue belt path and stored. Ensure the SnugLock lockoff is rotated to the correct belt path. Remove the slack from the seat belt by pulling on the shoulder belt and close the SnugLock lockoff until you hear a click. The top tether is an important safety feature and in Canada it is so important that it is legally required to be used with all forward facing harnessed seats.
Always use it with a forward facing installation! The TrioGrow SnugLock manual clearly states that the top tether is required for all forward facing installations. Graco TrioGrow SnugLock — forward facing 4 year old. Our 4 year old model remains 38 pounds and 42 inches tall. She is using the TrioGrow SnugLock in the highest harness position and has about 1. For most children, the Position the seat on recline 6.
Pull the bottom seat pad out to expose the plastic shell, and lift the headrest pad out of the way. Remove the crotch buckle by rotating the bottom metal retainer clip to the side and pushing it up through the plastic shell. Graco TrioGrow SnugLock — open the storage container. Open the harness storage door in the inner back shell of the seat and place the harness, chest clip, buckle tongues and crotch buckle inside storage compartment.
Graco TrioGrow SnugLock — place the harness, chest clip, and buckle in the storage container. Graco TrioGrow SnugLock — harness and buckles stored for booster mode. Close the door, replace the seat pad and adjust the headrest to the correct position for the child using the seat red shoulder belt guide just above their shoulder.
Graco TrioGrow SnugLock 7 year old booster mode. This model is 7 year old, 52 inches tall and weighs 56 pounds and yes, she is dressed the same as her younger sister above. Need help? Ask a question. Is there another insert I can order for a toddler. Answer this question. Is it safe for a baby to sleep in a Car seat? No, the baby could suffocate. If a baby falls asleep in the Car seat, the baby should be removed from the Car seat and placed in a cradle.
Once asleep, take the baby out and put it in its own cradle as soon as possible. Does my two-year-old child need a car seat on the plane?
Comments
Post a Comment